Gal yra žinančių kaip užkoduoti audi raktelį, kad veiktų užrakinti mašiną prie stojkės tos, kur iš lauko pusės yra IR...

Radau kažkokia instrukciją, bet nevisai ją supratu:

NOTE: Use key that is not fitted with remote control.

1. manually lock vehicle using key
2. Complete the following within 30 seconds, one key at a time
3. point key to be programmed at receiver. Located in b pillar on both sides.
4. within 5 seconds press lock/unlock button on each key 1-4 times at intervals of at least 1 second
5. once for memory position 1 (first key)
6. twice for memory position 2 (second key)
7. three times for memory position 3 (third key)
8. four times for memory position 4 (fourth key)

Dar vienas būdas rastas forume: Do you have memory seats as well? If so follow these steps I am going to refer to the keys as A and B as you have 2 of them
1) Unlock car with key A
2) Turn ignition into ON position with key A and roll down the window
3) Point Key B at IR Sensor and Click twice (perform both clicks under 5 seconds)
4) Turn off ignition and pull Key A out
5) Turn ignition into ON position with Key B
6) Point Key A at IR Sensor and Click once
7) Turn off ignition and Pull Key B out

Key A should be programmed as the Master Seat Program and Key B should be programmed for the Secondary seat program
So when you set your memory seats Key A is for Memory Position 1 and Key B is for memory position 2
if you don't have memory seats then you only have to point the receiver at the sensor and click once. That should just sync the IR Frequency and Codes