Gal kas zinote daugiau apie siuos zibintus?

http://www.euro-audi-parts.com/turbosducta.jpg


Pagal forma matau kad pritaikyti RS2, bet man patinka ju forma 
Cia originali dalis ar kazkoks perdarymas?
Imanoma lietuvoje toki daigta pagimdyti?
Pvz.: panaudojant turimo rukinio zibinto dalis (lesi...) o korpusa is stiklo pluosto ar ko... ?

siulau keisti temos pavadinima i "B4 kapotas ant B3".
Visiems tikrai aiskiau bus 

o dbr isklausykite tiesa ponai

jos nesiskiria- tik vienom ten tie kampuciai statosi o kitom posukis prisukima uzdengia.
va B4 nuo B3 tik skiriasi priesrukiniai....

Patikslinsiu, gal ir pats remelis b3 ir b4 nesiskiria, o skiriasi pats stikliukas (truputeli pavirsius kitu kampu stovi ) Pats isitikinau, todel dabar ieskau b4 halo stiklu ir negaunu!!!  Audi centras uz rema su stiklu nori apie 200 su kazkiek lietuvisku pinigu (issiziojau suzinojes kiek pilnas zibintas (su lesiu) - apie 600lt... vienas  ), ogmita su visais lesiais uz nauja ~180lt...

Viskas yra visiškai identiška, nėra jokių ilgių skirtumų ar pan, tik kai nėra šalia priešrūkinio posūkio, tai jis užsidengia specialiu kampeliu. Jo kaina naujo 15lt., jei kartais komplekte pirkdamas negautum.

O kur ju nauju pirkti? maniau jog deficitas

gal ten ir b4 halo stiklu galima rasti?

del faru apiplovimo jau nuo seniau zinau, jog eikvoja beveik be reikalo skysti. O man butent idomu ar kitoks skyscio purskimas nesutaupo kazkiek tai jo nes pvz valdiskame VW Caddy (2005m) langus apipurskia sia migla, ir palyginus nedaug skyscio i sonus nubraukiama, nors stiklai nusausinami graziai 

o ciurkos neprigamina tokiu, kurie tiktu audinems be burtu? 

o jei geometrija ir ratu geometrija? kaip tada? ar tas pats ar skirtingos paslaugos?

Pasitikslinimui:

Ratu suvedimas ir geometrija, tai ta pati paslauga ar skirtingos?

laidas gali buti nusilankstes. (ties ta vieta kur is kebulo i bagazines dangti eina)

Remove wood/window switch insert, disconnect wires if you are going to remove the door panel.

Remove the 10mm? or 8mm? screw also.

Remove the trim piece around the lower door handle cover, be careful. It's difficult to get this piece inserted back in correctly, you might need to tap it with a rubber mallet and either use a rag or you'll have a big scuff mark.

Back of wood piece.

Audi A8 Audi A8 Front and Rear Door Trim Removal

Note 1: You MUST HAVE a nylon trim stick to do this. I expect that if you try to get by with a screwdriver, you will booger something up.

Note 2: The Bentley CD misses about half the fasteners needed to remove the trim. If you're reading the manual, and looking at this, that's why they're so different.

   1. Pry off the wood trim with a nylon trim stick. This will reveal 3 large Phillips head screws that are a major part of what holds the trim to the door. These screws are not mentioned by Bentley. See pictures below of 97 door panel which has push connectors versus screws.

   2. Pry off the lower door handle cover with a trim stick. This will reveal 2 screws that, when removed, allow removal of the upper door handle cover. Beneath that are two larger screws that attach the door handle to the door.

   3. You'll need to lock the door, so you can work the top of the door trim over the pop-up. To the left of the arrow, there's a little Phillips screw in the door end at the trim that you'll need to remove.

   4. There are a zillion plastic pop-ons around the lower perimeter of the door. Start at one end with the trim stick, and pop off the trim panel.

   5. Once you get the trim panel loose, there's a cute little mechanism connecting the door handle to the door locks. Lots of small parts. Examine carefully before you remove. You may not need to, for what you're doing.



Rear Door Panel Removal
A lot of these procedures are applicable to the above front door procedure.

Here are the tools you will need, it also includes an 8mm socket if you want to totally remove the panel.